easy wood projects
Our basement needed new paint and flooring and a few minor renovations. In our large "living room" or "rec room" I wanted to put up a beam with lights in it. Here is what I was dealing with:
Ceiling right side |
Ceiling left side |
The total length, just under 16, was far too long to put one piece of wood, so there had to be joints in the beam. Instead of just straight joints I realized I could highlight the joint and make it look like a dovetail, so I made two joints along the length of the beam like this.
The beam would be hollow and allow four pot lights to be put inside. I decided to make it like this, with plywood sides and bottom, and 2x2s to screw the box sides to.
I used basic plywood which I cut into strips. I drew out a dovetail on the end of my side pieces and cut with a jigsaw.
I then laid the cut piece over another to cut the piece that the dovetail would fit into.
This is how they would look joined together:
I measured out to find where the holes needed to be for the pot lights and cut those out of my bottom pieces:
I screwed the 2x2 pieces to the ceiling after finding wood studs behind. My husband set up the electrical wiring so that it came out where the end of the beam would be. You can see those wires hanging down at the bottom of this photo. This runs from two switch boxes, one at the bottom of the stairs and one at the opposite far end of the beam.
Ill post the finished results next time, stay tuned! Heres the link
Sharing at:
My Repurposed Life
Do you find information about easy wood projects are you looking for? If not, below may help you find more information about the easy wood projects. Thank you for visiting, have a nice day.
0 komentar:
Posting Komentar